The research on using natural fibres as the reinforcement in plastic composites has increased dramatically in the last few years. Flax fibres are renewable resources with low specific mass, reduced energy consumption, and relatively low in cost. These advantages make flax fibres recognized as a potential replacement for glass fibres in composites. Among plastic, polyethylene was concluded to be a suitable material used as matrix in natural fibre reinforced biocomposites. However there are few studies on this area so far. In this paper, the processing method of flax fibre-reinforced polyethylene biocomposites is introduced. Flax fibre polyethylene biocomposite consists of flax fibre as the reinforcing component and high density polyethylene as the matrix. Acrylic acid pre-treatment was applied to flax fibre to improve the bonding between fibre and polyethylene. Extruding was used to mix materials and injection molding technique was carried out to process materials to certain shape biocomposites. The injection temperature and pressure were studied during injection molding to determine appropriate processing parameters for the biocomposites at different fibre content.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Impact of Fiber Loading on Injection Molding Processing Parameter and Properties of Biocomposite


    Weitere Titelangaben:

    Sae Int. J. Commer. Veh


    Beteiligte:

    Kongress:

    SAE 2010 Commercial Vehicle Engineering Congress ; 2010



    Erscheinungsdatum :

    2010-10-05


    Format / Umfang :

    6 pages




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Oil Palm Fiber Biocomposite for Automotive Industries

    Panigrahi, Satya | SAE Technical Papers | 2010


    Development and characterization of MWNTs/Chitosan biocomposite fiber

    Piri, N. / Mottaghitalab, V. / Arbab, S. | British Library Online Contents | 2013


    Automatic loading device and method for injection molding machine

    CHEN YUAN / ZHANG PENG / ZHAO WANGQI et al. | Europäisches Patentamt | 2024

    Freier Zugriff

    Reaction Injection Molding with Glass Fiber Reinforcement

    Isham, Allan B. | SAE Technical Papers | 1978


    PROCESSING APPARATUS AND INJECTION MOLDING METHOD

    LI YANHUA / CHEN AIHUA | Europäisches Patentamt | 2022

    Freier Zugriff