This standard covers plain and flanged sleeve bearings which are self-lubricating by incorporating polytetrafluoroethylene (PTFE) in a liner in the bore for use in the temperature range of -65 to +325 °F. This document includes limited scope changes to the following sections in response to comments from the approved Rev. C ballot (April 2019): 3.6.2, 4.3.1, 4.3.3, 4.6.6.2, and Figure 1. Previously approved changes from Rev. B to Rev. C: Updating the high/sub-zero temperature test methods, room temperature break-in cycles, qualification requirements by similarity to AS81820 for CRES substrates, and test pin and housing tolerances. Adding/updating fluid contaminants and specifying type and concentration of anti-icing fluid to be used for testing. Adding retention of qualification requirements for aluminum substrate. Clarifying tables and text to address conflicting requirements for number of qualification test samples required. Clarifying when LN2 exposure is required.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Bearings, Sleeve, Plain and Flanged, Self-Lubricating


    Erscheinungsdatum :

    2019-09-16



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch