Full-scale vehicle tests were made on a standard-type passenger car in a wind tunnel and on the road in order to evaluate different moving-ground simulation techniques for wind tunnels.The test was first executed over a moving belt, supporting the car with a rear sting and measuring the aerodynamic forces with an internal balance.The test was then repeated with the same support arrangement over a fixed test-section floor, and moving-ground simulation was attained with boundary layer control by tangential blowing.Besides force measurements, the surface pressure distribution underneath the vehicle and at the base were also measured. Furthermore, the velocity distribution between vehicle and ground floor was assessed by measuring the total-pressure distribution.In order to compare the results with road tests the interference effects of the sting support and the wheel gap were investigated with the car sitting on the tunnel floor and forces measured on the external balance of the tunnel. Initially, the sting support was present but disconnected from the internal balance; finally, it was removed from the test section altogether.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Ground Simulation with Moving Belt and Tangential Blowing for Full-scale Automotive Testing in a wind Tunnel


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Mercker, E. (Autor:in) / Knape, H.W. (Autor:in)

    Kongress:

    SAE International Congress and Exposition ; 1989



    Erscheinungsdatum :

    1989-02-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Ground simulation with moving belt and tangential blowing for full-scale automotive testing in a wind tunnel

    Mercker,E. / Knape,H.W. / German-Dutch Wind Tunnel,NL et al. | Kraftfahrwesen | 1989


    Moving-Ground Simulation by Tangential Blowing

    J. E. Hackett / R. A. Boles | AIAA | 1979


    Moving ground simulation by tangential blowing

    HACKETT, J. / BOLES, R. | AIAA | 1978


    Full-scale moving belt in Fiat aerodynamic wind tunnel

    Berta,C. / Fiat,Turin,IT | Kraftfahrwesen | 1990