A three-dimensional model of a diesel engine intake port was established and was verified by steady-flow test. Based on this model, the influence of intake valve lift on the flow capacity of intake port was studied and a design method of maximum valve lift was put forward. The results show that, under different intake pressure and relative pressure difference conditions, the discharge coefficient increases first and then converges with the increase of valve lift. Under the same valve lift condition, with the increase of relative pressure difference, the discharge coefficient decreases slightly in subsonic state and decreases sharply from subsonic state to supersonic state, but the mass flow rate increases slightly. The optimum ratio of valve lift and valve seat diameter is related to relative pressure difference, it increases first and then keeps constant with the increase of relative pressure difference. When the optimum maximum valve lift is design, The optimum maximum valve lift at the working condition of maximum relative pressure difference can be used as the optimum value in the whole working conditions.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Influence of Intake Valve Lift on Flow Capacity of Intake Port


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Liu, Fushui (Autor:in) / Rui, Jingmin (Autor:in) / Hua, Yang (Autor:in) / Xu, Yang (Autor:in) / Li, Yikai (Autor:in)

    Kongress:

    WCX SAE World Congress Experience ; 2019



    Erscheinungsdatum :

    2019-04-02




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Influence of Intake Valve Lift on Flow Capacity of Intake Port

    Xu, Yang / Liu, Fushui / Rui, Jingmin et al. | British Library Conference Proceedings | 2019


    Effects of Intake Port Design and Valve Lift on In-Cylinder Flow and Burnrate

    Mikulec, A. / Davis, G. C. / Kent, J. C. et al. | SAE Technical Papers | 1987


    Intake and Cylinder Flow Modeling with a Dual-Valve Port

    Rutland, C. J. / Pieper, C. M. / Hessel, R. | SAE Technical Papers | 1993


    Intake and Cylinder Flow Modeling with a Dual-Valve Port

    Rutland,C.J. / Pieper,C.M. / Hessel,R. et al. | Kraftfahrwesen | 1993


    Performance=Robbing Aspects of Intake Valve and Port Deposits

    Gething, J. A. | SAE Technical Papers | 1987