Design of sheet metal drawing processes requires accurate information about the distribution of restraining forces, which is usually accomplished by a set of drawbeads positioned along the perimeter of the die cavity. This study is targeting bringing together the results of finite element analysis and experimental data in order to understand the most critical factors influencing the restraining force. The experimental study of the restraining force was performed using drawbead simulator tool installed into a tensile testing machine. Based upon the experimental results, it was observed that the restraining force of the given drawbead configuration is dependent upon the depth of bead penetration, friction between the drawbead surfaces as well as the clearance between the flanges of the drawbead simulator. This clearance is often adjusted during stamping operations to increase or decrease material inflow into the die cavity without any modification in the die. Numerical simulation was performed with Autoform software following the geometry of the experimental drawbead tools used in this study. Two different surface conditions were used in the experimental tools: surface treatment 1 and surface treatment 2. Based on performed numerical simulation, the observations were made that the sheet metal does not conform with beads geometry for larger clearances between the sheet and the beads as well as for smaller bead penetrations.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Experimental and Analytical Study of Drawbead Restraining Force for Sheet Metal Drawing Operations


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    WCX SAE World Congress Experience ; 2020



    Erscheinungsdatum :

    14.04.2020




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Experimental and Analytical Study of Drawbead Restraining Force for Sheet Metal Drawing Operations

    Reinberg, Natalia / Mokashi, Ashutosh / Nasheralahkami, Saeid et al. | British Library Conference Proceedings | 2020


    Experimental and Analytical Study of Drawbead Restraining Force for Sheet Metal Drawing Operations

    Reinberg, Natalia / Mokashi, Ashutosh / Nasheralahkami, Saeid et al. | British Library Conference Proceedings | 2020


    Drawbead Restraining Force Modeling: Nonlinear Friction

    Ren, Feng / Chappuis, Laurent / Xia, Z. Cedric | SAE Technical Papers | 2009


    Drawbead Restraining Force Modeling with Anisotropic Hardening

    Zeng, Danielle / Sun, Jixian / Zhu, Xinhai et al. | SAE Technical Papers | 2010


    An experimental technique to determine the behaviour of sheet metal in drawbead

    Green,D.E. / International Research and Development Institute,US | Kraftfahrwesen | 2001