This paper presents a simplified approach for formability simulation of automotive body structural sections in the early design stage of vehicle development process. Plane strain approach is investigated for its applicability and accuracy by comparing the analytical results with the measured results of automotive body side panel. The plane strain approach was tried based on the fact that for a certain section location of a stamped panel, the minor strains are relatively small and negligible compared to the major strains. The state of plane strain can be induced mainly through symmetry and applied boundary conditions. This approach is both cost effective and time saving for analyzing sheet metal formability in early vehicle development stage, since only few sections of the entire panel need be analyzed. To demonstrate the accuracy and effectiveness of the approach the analytical results of the commercial FEA software AUTOFORM2.1 is used in comparison with the results from actual measurements.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Simplified Approach for Formability Simulation of Automotive Body Structures


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Kim, Hakcheen (Autor:in) / El-Sayed, Jacqueline (Autor:in) / Frutiger, Robert (Autor:in) / Liu, William (Autor:in)

    Kongress:

    International Body Engineering Conference & Exposition ; 2001



    Erscheinungsdatum :

    16.10.2001




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Simplified approach for formability simulation of automotive body structures

    El-Sayed,J. / Kim,H. / Frutiger,R. et al. | Kraftfahrwesen | 2001


    Plane strain formability analysis of automotive body structures using DYNA2D

    El-Sayed, J. / Kim, H. / Frutiger, R. | Tema Archiv | 2004


    High Strength Steel Tube with Excellent Formability for Automotive Body Parts

    Atatani, M. / Ishiguro, Y. / Sonobe, O. et al. | British Library Conference Proceedings | 2010


    Simulation and formability of automotive aluminum alloy sheet and tube

    Worswick, M.J. / Orlov, O. / Winkler, S. | Tema Archiv | 2006


    On the formability of automotive trip steels

    Konieczny,A.A. / United States Steel,US | Kraftfahrwesen | 2003