Approximately four years ago, new production process for automobile door liners was introduced in Europe. The process consisted of stretching a sheet of unsupported, expanded PVC over the mold cavity. The mold was closed and clamped and a polyurethane structural foam mixture was injected by the RIM method through the top half of the mold. The pressure and temperature of the expanding mixture forced the vinyl to conform to the contours of the cavity thus producing a finished door liner (polyurethane foam/vinyl composite). This process showed promise but had several drawbacks. Over the past two years, cycle times have been reduced to 2 minutes, intricate surface detail has been achieved and other formable surfaces have been substituted for the vinyls.These improvements have made it a candidate product for the U.S. auto industry.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    RIM Urethane/Vinyl Composites as interior Trim Parts


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Mann, Max F. (Autor:in)

    Kongress:

    SAE International Congress and Exposition ; 1982



    Erscheinungsdatum :

    01.02.1982




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    RIM urethane/vinyl composites as interior trim parts

    Mann,M.F. / Mobay Chemical,US | Kraftfahrwesen | 1982


    Advances in Urethane Foam Composites for Interior Trim

    Hurley, Michael F. / Dempsey, Michael P. | SAE Technical Papers | 1991


    Advances in urethane foam composites for interior trim

    Dempsey,M.P. / Hurley,M.F. / Mobay,US | Kraftfahrwesen | 1991


    URETHANE AND GRAPHENE INTERIOR TRIM PANEL

    REDDY MURALI MOHAN / FARRAR GREGORY JAMES | Europäisches Patentamt | 2022

    Freier Zugriff