Groove designs presented herein are applicable for use with machined or formed metal seals which are similar in configuration to those shown in figure 3, which operate under internal pressure or in vacuum service and which have been specifically qualified or recommended by the purchaser or the manufacturer for use with this AIR. They are also applicable for use with metal o-rings (e.g., MS9142, MS202 thru MS9205) where interchangeability with machined or formed metal seals is desired. For metal o-ring groove designs where inter-changeability is not a requirement refer to ARP 674. AIR1108 has been reaffirmed to comply with the SAE five-year review policy.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Groove Design - Metal Face Seal


    Erscheinungsdatum :

    28.10.2013



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Groove Design - Metal Face Seal

    SAE Technical Papers | 2019


    METAL RING SEAL GROOVE DESIGN

    SAE Technical Papers | 1964


    Analytical investigation of the spiral groove face seal

    Sneck, H. J. / Mcgovern, J. F. | NTRS | 1973


    Analysis of brake caliper seal-groove design

    Anawana,O.D. / Cai,H. / Chang,H.T. et al. | Kraftfahrwesen | 2002


    Analysis of Brake Caliper Seal-Groove Design

    Chang, H. T. / Cai, Hao / Anwana, Okon D. | SAE Technical Papers | 2002