A simple method is frequently used to calculate a reciprocating engine’s bearing load from the measured cylinder pressure. However, it has become apparent that engine downsizing and weight reduction cannot be achieved easily if an engine is designed based on the simple method. Because of this, an actual load on a bearing was measured, and the measured load values were compared with a bearing load distribution calculated from cylinder pressure. As a result, it was found that some of actual loads were about half of the calculated ones at certain crank angles. The connecting rod’s elastic deformation was focused on as a factor behind such differences, and the rod’s deformation due to the engine’s explosion load was studied. As a result, it was found that the rod part of the engine’s connecting rod was bent by 0.2 mm and became doglegged. Additional investigation regarding these findings would allow further engine downsizing.In this paper, the authors mainly report that an actual load on a bearing during the engine’s combustion could not be determined by simplified calculation based on the engine’s cylinder pressure, and that it is necessary to take into account a connecting rod’s deformation as well as a piston ring’s friction and a crank shaft’s deformation which were not measured at this time. As a follow up of this report, the authors plan to report minimum oil film thickness and the distribution of oil film thickness with respect to an engine’s individual rotation speed when Elastohydrodynamic Lubrication (EHL) is used.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    In-Situ Measurement and Numerical Solution of Main Journal Bearing Lubrication in Actual Engine Environment


    Weitere Titelangaben:

    Sae Int. J. Fuels Lubr
    Sae International Journal of Fuels and Lubricants


    Beteiligte:
    Harada, Hironori (Autor:in) / Matsumoto, Kenji (Autor:in) / Mihara, Yuji (Autor:in) / Ono, Yuki (Autor:in)

    Kongress:

    SAE 2016 World Congress and Exhibition ; 2016



    Erscheinungsdatum :

    05.04.2016


    Format / Umfang :

    4 pages




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    In-Situ Measurement and Numerical Solution of Main Journal Bearing Lubrication in Actual Engine Environment

    Matsumoto, Kenji / Harada, Hironori / Ono, Yuki et al. | British Library Conference Proceedings | 2016


    Surface and engine oil effects on journal bearing lubrication

    Sorab,J. / Korcek,S. / Ford Motor,US | Kraftfahrwesen | 1998


    Surface and Engine Oil Effects on Journal Bearing Lubrication

    Sorab, Jagadish / Korcek, Stefan | SAE Technical Papers | 1998