A Constant Volume Sampler (CVS) over dilutes the exhaust gas sample when testing Plug-In Hybrid Electric Vehicles (PHEV). This is because the CVS continues to fill the sample bag when the engine is shutdown. With a PHEV, it is possible to complete an FTP test with the engine running less than 20% of the time, resulting in a CVS bag dilution ratio in the range of 100 to 300. The CVS dilution ratio should be in the range of 5-25 for accurate results. At higher dilution ratios, the gas concentrations of CO, NOx and THC approach the ambient background level in the test cell. At a dilution of 100, the CO₂ concentration in the sample bag is about 0.13%, which is only 3 times the air background concentration. The measurement errors caused by over dilution create errors of 10% to 30% in the calculated mass of CO₂, CO, and NOx. Estimated errors for THC are in the range of 200%.Many of the limitations of a CVS can be eliminated by using a partial flow sampling system, such as a bag minidilutor (BMD), which maintains a constant dilution ratio of 5:1 at all exhaust flow rates. A BMD dilutes the exhaust gas with pure air, so no background correction for ambient air contamination is necessary. Testing a PHEV still poses measurement issues with a BMD, because the internal combustion engine may not run long enough during a test for the BMD to acquire a volume of exhaust gas sample sufficient for the gas analyzers to read accurately.Modifications have been made to the CVS and BMD hardware and software to improve the measurement accuracy for PHEV testing. Vehicle emission data obtained with the modified test equipment is compared to data obtained previously with standard CVS and BMD sampling systems.
Improved PHEV Emission Measurements in a Chassis Dynamometer Test Cell
Sae Int. J. Engines
SAE 2010 World Congress & Exhibition ; 2010
Sae International Journal of Engines ; 3 , 1 ; 1113-1123
2010-04-12
11 pages
Aufsatz (Konferenz)
Englisch
Improved PHEV emission measurements in a chassis dynamometer test cell
Kraftfahrwesen | 2010
|On-Road and Chassis Dynamometer Evaluation of a Pre-Transmission Parallel PHEV
British Library Conference Proceedings | 2019
|On-Road and Chassis Dynamometer Evaluation of a Pre-Transmission Parallel PHEV
SAE Technical Papers | 2019
|Validating Volt PHEV Model with Dynamometer Test Data Using Autonomie
SAE Technical Papers | 2013
|Accuracy of exhaust emission factor measurements on chassis dynamometer
Tema Archiv | 2009
|