Flash butt welding process has been widely used in the fabrication of wheel-rims in the automobile industry because of its high production efficiency. On the other hand, a DC butt welding process has been recently developed and put into practice for wheel-rim production instead of the flash butt welding process. The reasons seem to be higher production efficiency, energy savings and clean environment (no flash). There are many reports1)∼3) on flash butt welding, but there are little, if any reports on DC butt welding.In this report, the DC butt welding process was studied from the view point of comparison with the flash butt welding process. The weld defect formed in flash butt welding is mainly oxide inclusion (Si-Mn-Al oxide) at weld interface. On the other hand, in DC butt welding the cold weld and overheat cracking due to heat input are main weeld defects. Such defects in DC butt welding are controlled by the welding conditions; that is, welding current, welding time and electrode pressure which are 3 main control factors in resistance welding, such as spot welding, as heat input of DC butt welding is generated by joule's heat. In addition, though the heat input along the weld line is uniform in flash butt welding, it is non-uniform in DC butt welding. It is generally generated near both plate side edges. In the case of higher heat input, the growth of the overheat cracking is initiated at both plate side edges. This phenomena that nonuniform heat input is generated is characteristic of DC butt welding.Maximum hardness of welded joint is higher in DC butt welding than that in flash but welding, because the cooling rate is higher in DC butt welding due to lower heat input.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    DC Butt Welding Process for Wheel-Rim


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Nakanishi, Mutsuo (Autor:in) / Yamauchi, Nobuyuki (Autor:in) / Taka, Takao (Autor:in)

    Kongress:

    SAE International Congress and Exposition ; 1988



    Erscheinungsdatum :

    01.02.1988




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    DC butt welding process for wheel-rim

    Taka,T. / Nakanishi,M. / Yamauchi,N. et al. | Kraftfahrwesen | 1988


    DC butt welding process for wheel-rim

    Taka, T. / Nakanishi, M. / Yamauchi, N. | Tema Archiv | 1988



    BUTT WELDING STRUCTURE AND BUTT WELDING METHOD FOR EXTREMELY THICK STEEL PLATE

    YAMAUCHI AKIHIKO / KIJI NOBORU / TOYODA MASANOBU | Europäisches Patentamt | 2016

    Freier Zugriff

    New oxy-acetylene process for butt-welding rails

    Engineering Index Backfile | 1939