Especially in view of more and more stringent emission legislation in passenger cars it is required to reduce the amount of pollutants. In the case of Diesel engines mainly NOx and PM are emitted during engine operation. The main influence factors for these pollutants are the in-cylinder oxygen concentration and the injected fuel amount. Typically the engine control task can be divided into two separate main parts, the fuel and the air system. Commonly air system control, consisting of a turbocharger and exhaust gas recirculation control, is used to provide the required amount of oxygen and address the emission targets, whereas the fuel is used to provide the desired torque. Especially in transient maneuvers the different time scales of both systems can lead to emission peaks which are not desired.Against this background in this work instead of the common way to address the air system, the fuel system is considered to reduce emission peaks during transients. The idea is to start from a base calibration and adapt the injection parameters, like start and amount of pilot and main injection, to reduce transient emission peaks. To this end, an input shaping technique is applied to adapt parameters. The input shaping is based on an identified response model of the transient emission profile and used to generate a desired correction trajectory. By input shaping it was possible to reduce the NOx overshoot during the transient scenario while maintaining PM emissions and noise level. All experiments were performed on a 2l turbocharged common rail passenger car diesel engine at the JKU testbench and to obtain accurate NOx measurements during transients these were recorded with a highly dynamic Cambustion fNOx device.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Dynamic Injection Adaptation by Input Shaping for Low NOx Emissions during Transients


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Selmanaj, Donald (Autor:in) / Waschl, Harald (Autor:in) / del Re, Luigi (Autor:in) / Schinnerl, Michael (Autor:in) / Savaresi, Sergio (Autor:in)

    Kongress:

    SAE 2014 World Congress & Exhibition ; 2014



    Erscheinungsdatum :

    2014-04-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Computational Study of Injection Rate-Shaping for Emissions Control in Diesel Engines

    Boggavarapu, P. / Singh, S. | British Library Conference Proceedings | 2011


    input shaping training equipment

    SEONG WOOK HONG / CHOI DAE HAN / KIM YOUNG SHIN et al. | Europäisches Patentamt | 2020

    Freier Zugriff

    Computational Study of Injection Rate-Shaping for Emissions Control in Diesel Engines

    Boggavarapu, Prasad / Singh, Satbir | SAE Technical Papers | 2011


    The effect of EGR System response time on NOx feedgas emissions during engine transients

    Throop,M.J. / Cook,J.A. / Hamburg,D.R. et al. | Kraftfahrwesen | 1985