This test procedure is intended to apply to hydraulic pump suction filters and strainers used in automotive automatic transmissions that include hydraulic power pumps. The various paragraphs of Section 5 include a variety of tests and alternative tests that are not applicable to all filters and applications, so the engineer must specify which tests are to be performed for a particular application. These test procedures are intended to evaluate filter functional performance characteristics only, durability is not evaluated under this standard. Filter design requirements must be specified by the engineer on the filter assembly drawing, an applicable engineering specification, or summarized on an application data sheet similar to that found in this recommended practice. See Figure 6. Pressure circuit filters, both barrier and system contamination control types, are not covered under this standard. They are similar in design and construction to filters used in many hydraulic and lubricating applications. Testing for pressure filters are covered by the ISO and SAE standards listed under references in Section 2. This document has been revised for clarity, simplification, and inclusion of the latest advances in transmission intake filter validation testing.
Automatic Transmission Intake Filter Test Procedure
2021-06-22
Aufsatz (Konferenz)
Englisch
Automatic Transmission Intake Filter Test Procedure
SAE Technical Papers | 2013
Automatic Transmission Intake Filter Test Procedure
SAE Technical Papers | 2005
Automatic Transmission Hydraulic Pump Test Procedure
SAE Technical Papers | 2020
Automatic Transmission Hydraulic Pump Test Procedure
SAE Technical Papers | 2015
Automatic Transmission Hydraulic Pump Test Procedure
SAE Technical Papers | 1999