Hot stamping or so-called continuous press hardening is a process to make sheet metal parts with yield-tensile strength up to 1150Mpa-1550Mpa. Due to the high specific ratio of quenched Boron steels, which is higher than those of aluminum alloys and magnesium alloys, the components with low mass can be made from hot stamped Boron steels. In current industrial practice, direct hot stamping process, which forms a part directly from a flat sheet blank, is normally used to make geometries with relatively mild deformation, such as B-pillars, A-pillars etc. In this study, indirect hot stamping is introduced to develop geometries with a deep cavity and complex form features. Since the indirect hot stamping develops the part cavity depth in cold drawing and then forms detail features in hot stamping, part with complex geometry can thus be formed. A rocker component is chosen to demonstrate the technology. The rocker component, which can't be made by HSLA350 without design changes, can now be formed by indirect hot stamping. Due to the dramatic increase of strength, a potential mass reduction up to 20% can also be achieved.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Deep Drawing by Indirect Hot Stamping


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Liasi, Evangelos (Autor:in) / Miller, Robert (Autor:in) / Chang, Tony (Autor:in) / Wang, Yuwei (Autor:in) / Sheng, ZiQiang (Autor:in)

    Kongress:

    SAE 2013 World Congress & Exhibition ; 2013



    Erscheinungsdatum :

    08.04.2013




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Deep Drawing by Indirect Hot Stamping

    Sheng, Z. / Wang, Y. / Chang, T. et al. | British Library Conference Proceedings | 2013


    DEEP-DRAWING DEVICE

    MATHEISL MICHAEL / NOVACEK THOMAS / KHU PETER | Europäisches Patentamt | 2016

    Freier Zugriff

    Hydromechanical deep-drawing

    Siegert, K. / Aust, M. | Tema Archiv | 2000


    Car body side body stamping method using drawing sill, die and car body side body

    ZHANG WENTAO / ZHANG YONG / ZHOU HOUXIN et al. | Europäisches Patentamt | 2023

    Freier Zugriff

    Drop-stamping

    Engineering Index Backfile | 1943