In automotive wind tunnels with modern road simulation installations boundary layer pre-suction is a widely-used technique for boundary layer control. The consequence of boundary layer pre-suction is an additional pressure gradient in front of the model. In order to investigate the effects of the additional pressure gradient on drag, experiments were conducted with two different models (scale 1:5) in the IVK Model Wind Tunnel. In these experiments the suction velocity of the boundary layer pre-suction served as a parameter to change the static pressure gradient along the test section and was for this purpose adjusted higher and lower than the standard suction velocity. It is shown that the total drag increment due to boundary layer pre-suction consists of at least two parts: the ground simulation increment and the static pressure gradient increment. The ground simulation increment is due to a decrease in the boundary layer thickness and the resulting modified flow beneath the model. The static pressure gradient increment is due to the unintended additional pressure gradient. Furthermore a method is described to separate both increments and a correction method is proposed to correct the additional gradient effect.
Further Investigations on Gradient Effects
Sae Technical Papers
SAE 2004 World Congress & Exhibition ; 2004
2004-03-08
Aufsatz (Konferenz)
Englisch
Further Investigations on Gradient Effects
British Library Conference Proceedings | 2004
|Further investigations of gradient effects
Kraftfahrwesen | 2004
|2004-01-0670 Further Investigations on Gradient Effects
British Library Conference Proceedings | 2004
|Further Investigations in Vehicle Dynamics
SAE Technical Papers | 1970
|Further Investigations on Time-Alignment
British Library Conference Proceedings | 2004
|