A major problem with making accurate cylinder pressure measurements using piezoelectric pressure transducers in IC engines is thermal shock. This affects most derived parameters although the greatest error is in the indicated mean effective pressure (IMEP), which can be affected by over 10%. In this paper, thermal shock has been quantified for a wide range of engine conditions. Thermal shock was found to be most significant at low engine speeds, high loads and advanced ignition timings. A good correlation between thermal shock and peak pressure has been established for Kistler 6123 and 6125 transducers when dealing with cycle averaged data. This resulted in the development of a numerical thermal shock correction routine which was used for all subsequent data processing. Use of this improved analysis software demonstrated that the error in the calculated IMEP was significantly improved for the Ford Zetec engine tested. The range of Kistler 6123 IMEP errors were reduced from between -7% and -20% to between -1.5% and +1.4% after correction. Equivalent values for a Kistler 6125A transducer were -4.9% to -2.1% uncorrected down to between -0.4% and +0.8%.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Quantification and Reduction of IMEP Errors Resulting from Pressure Transducer Thermal Shock in an S.I. Engine


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    International Congress & Exposition ; 1999



    Erscheinungsdatum :

    1999-03-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Evaluation of IMEP routines and analysis errors

    Brunt,M.F. / Emtage,A.L. / Loughborough Univ.of Technology,GB et al. | Kraftfahrwesen | 1996


    Evaluation of IMEP Routines and Analysis Errors

    Emtage, Andrew L. / Brunt, Michael F. J. | SAE Technical Papers | 1996


    Measurement errors in real-time IMEP and ROHR evaluation

    Corti,E. / Moro,D. / Solieri,L. et al. | Kraftfahrwesen | 2008


    Quantification of thermal shock in a piezoelectrical pressure transducer

    Lee,S. / Bae,C. / Prucka,R. et al. | Kraftfahrwesen | 2005