Restricted hardenability steels have been in use for some time but the specific restrictions for a particular grade depend upon customer needs and vary from mill to mill. Such steels are desirable to provide more controlled heat treatment response and dimensional control for critical parts. Because of increasing interest in steels with restricted hardenability, the SAE Iron and Steel Technical Committee directed Division 8 to prepare a set of standard steels with restricted hardenability. In 1993, the American Society for Testing and Materials (ASTM) adopted the twelve SAE restricted hardenability steels and added ten more. SAE decided to include in SAE J1868 the additional 10 steels. In general, steels with restricted hardenability (RH steels) will exhibit a hardness range not greater than 5 HRC at the initial position on the end-quench hardenability bar and not greater than 65% of the hardness range for standard H-band steels (see SAE J1268) in the "inflection" region. Generally the restricted hardenability band follows the middle of the corresponding standard H-band. An example of the RH band compared with the standard H-band is given for SAE 4140 in Figure 1. Page 2 Item 6 Grain Size: Deleted SAE J418 because SAE cancelled that specification in May 1999. Replaced it with equivalent ASTM specification E 112. Page 4 Note 3: Deleted all references to tables because they are currently under review and have not been balloted. Left in reference to SAE J409. Added ASTM E 112 to section 2.1.2.
Restricted Hardenability Bands for Selected Alloy Steels
15.02.2010
Aufsatz (Konferenz)
Englisch
Test procedures , Chemicals , Iron , Copper , Alloys , Heat treatment , Steel , Chromium , Nickel
RESTRICTED HARDENABILITY BANDS FOR SELECTED ALLOY STEELS
SAE Technical Papers | 1990
RESTRICTED HARDENABILITY BANDS FOR SELECTED ALLOY STEELS
SAE Technical Papers | 1993
RESTRICTED HARDENABILITY BANDS FOR SELECTED ALLOY STEELS
SAE Technical Papers | 1988
HARDENABILITY BANDS FOR ALLOY H STEELS
SAE Technical Papers | 1977
HARDENABILITY BANDS FOR CARBON AND ALLOY H STEELS
SAE Technical Papers | 1981