Micro-machined planar orifice nozzles have been developed and used with commercially produced diesel injection systems. Such a system may have the capability to improve the spray characteristics in DI diesel engines. The availability of a MEMS (Micro-Electro-Mechanical-Systems) processing sequence supported the construction of micro-planar orifice nozzles, and micro-systems technology was also employed in our macro-instrumentation.To demonstrate this process, fourteen MEMS nozzles were fabricated with deep X-ray lithography and electroplating technology. The circular orifice diameters were varied from 40 to 260 microns and the number of orifices varied from one to 169. Three plates with non-circular orifices were also fabricated to examine the effect of orifice shape on spray characteristics. These nozzles were then attached to commercial injectors and the associated injection systems were used for the spray experiments. Given these novel injection systems, jet spray characteristics of micro-machined nozzles were investigated experimentally at two different injection pressures. Current test results show the expected qualitative trends in spray kinematics and drop size, but the quantitative magnitudes of the behavior are less dependent on geometry than first anticipated. Specifically, high pressure data shows only modest gains with a multi-hole configuration. Non-planar configurations are expected to show improved performance.
Development of Micro-Diesel Injector Nozzles via MEMS Technology and Effects on Spray Characteristics
Sae Technical Papers
SAE 2001 World Congress ; 2001
2001-03-05
Aufsatz (Konferenz)
Englisch
SAE Technical Papers | 1999
|Spray Characteristics of Five-Hole V.C.O Nozzles of a Diesel Electro- Injector
SAE Technical Papers | 1994
|