This paper will discuss the stress reduction of the worm wheel for an electric power steering (EPS) system. The research discussed in this paper focused on the worm wheel, the EPS component that determines the maximum diameter of the system. If the stress of the worm wheel could be reduced without increasing in size, it would be possible to reduce the size of the worm wheel and EPS system. In order to reduce the stress of the worm wheel, the conventional design method has extended the line-of-action toward outside of the worm wheel to increase the contact ratio of the gears and these method lead to an increase in the outer diameter.In order to address this issue, past research proposes the basic concept to extend line-of-action toward the inside of the worm wheel. And this new meshing theory was named MUB (Meshing Under Base-circle) theory.In this paper, characteristics of meshing of the gear formed by MUB theory are determined in more detail. After that, an example of design guideline of the worm gear profile based on MUB theory is explained. And this worm gear was manufactured, installed into an EPS system, and tested. This paper will report on the findings made during the course of this research.
Consideration about Meshing of Worm Gear Based on MUB (Meshing Under Base-Circle) Theory for EPS
Sae International Journal of Passenger Cars. Mechanical Systems
Sae Int. J. Passeng. Cars - Mech. Syst
SAE 2014 World Congress & Exhibition ; 2014
Sae International Journal of Passenger Cars - Mechanical Systems ; 7 , 2 ; 458-467
2014-04-01
10 pages
Aufsatz (Konferenz)
Englisch
Experimental investigation of internal meshing worm drive
Kraftfahrwesen | 2015
|Design, simulation of meshing, and contact stresses for an improved worm gear drive
Online Contents | 2007
|