The reaction injection molding (RIM) of structural composites is a cost effective process. Raw material cost, glass and resin, may constitute 80-85% of the total part cost when the RIM process is used. Therefore, the optimum levels of glass and resin is important in relation to performance requirements and part weight objectives. This paper describes a new polycarbamate resin and economic considerations resulting from its use with several glass alternatives.
Reaction Injection Molded Composites-Properties and Economics
Sae Technical Papers
SAE International Congress and Exposition ; 1989
01.02.1989
Aufsatz (Konferenz)
Englisch
Reaction injection molded composites - properties and economics
Kraftfahrwesen | 1989
|Injection-molded carbon-fiber composites
Kraftfahrwesen | 1979
|Lightweight Reaction Injection Molded Polyurethane for Automotive Fascia
SAE Technical Papers | 1995
|Lightweight reaction injection molded polyurethane for automotive fascia
Kraftfahrwesen | 1995
|Lightweight reaction injection molded polyurethane for automotive fascia
Tema Archiv | 1995
|