Most current automotive catalytic converters use diffusers to distribute the flow field inside the monolithic bricks where catalysis takes place. While the characteristics and performance of a simple diffuser flow are well documented, the influence of downstream brick resistance is not clear. In this paper the trade-off between flow-uniformity and pressure drop of an axisymmetric automotive catalytic converters is studied numerically. The monolithic brick resistance is formulated from the pressure gradient of fully developed laminar duct-flow and corrected for the entrance effect. A distribution index was formulated to quantify the degree of non-uniformity in selected test cases. The test matrix covers a range of different diffuser angles and flow resistances (brick types). For simplicity, an axisymmetric geometry is chosen. Flow distribution within the monolith was found to depend strongly on diffuser performance, which is modified by brick resistance. Pressure drop due to the headers and brick resistance and their relative roles is also identified. The implications of these data for converter design is discussed in terms of the trade-off between flow-uniformity and pressure drop.
Modeling Diffuser-Monolith Flows and Its Implications to Automotive Catalytic Converter Design
Sae Technical Papers
International Conference On Vehicle Structural Mechanics & Cae ; 1992
1992-06-01
Aufsatz (Konferenz)
Englisch
Modeling diffuser-monolith flows and its implications to automotive catalytic converter design
Kraftfahrwesen | 1992
|The ceramic monolith in catalytic converter design
Kraftfahrwesen | 1974
|Sources of Monolith Catalytic Converter Pressure Loss
SAE Technical Papers | 1991
|Visualization of Automotive Catalytic Converter Internal Flows
SAE Technical Papers | 1986
|Visualization of Automotive Catalytic Converter Internal Flows
Kraftfahrwesen | 1986
|