Measurements of instantaneous temperature were made at three locations on the cylinder head of a direct injection diesel engine. Changes in calculated instantaneous heat flux with changes in cylinder head surface temperature were assessed. The results were used in an assessment of various approaches to the description of instantaneous heat transfer incorporated in diesel cycle simulations.It was concluded that changes in the thermal boundary layer thickness throughout the cycle could account for some of the observed phenomena. A close correlation was seen between the heat transfer measured here and earlier published studies of measured boundary layer thickness. Some additional indications from the measurements point to a significant thermal capacitance of the boundary layer. Additional work is needed to further understand the potential ramifications of this effect.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Measurement and Analysis of the Effect of Wall Temperature on Instantaneous Heat Flux


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Hoag, Kevin L. (Autor:in)

    Kongress:

    SAE International Congress and Exposition ; 1986



    Erscheinungsdatum :

    01.03.1986




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Development of a Thin-Film Thermocouple for Measurement of Instantaneous Heat Flux into Cast Iron Wall (20024431)

    Ishii, H. / Emi, M. / Suzuki, Y. et al. | British Library Online Contents | 2002




    Instantaneous Heat Flux Analysis of Premixed Lean Diesel Combustion (20024432)

    Harada, A. / Asaumi, Y. / Aoyagi, Y. et al. | British Library Online Contents | 2002