The fabrication process and mechanical testing procedures used by the Frankford Arsenal in production of 105mm sintered iron rotating bands are discussed. It was demonstrated that 105mm bands can be fabricated to meet the class 3 density range of the current military specification (MIL-R-11073) using conventional sintering temperatures (2050°-2100°F) and sintering atmospheres (dissociated ammonia). The major processing requirement was that density must be closely controlled and kept in the upper portion of the density range, approximately between 6.00 and 6.19 g/cc. Two commercial reduced type iron powders were found to be suitable for the production of these bands. The existing methods of test for tensile strength and ductility of bands in the specification appear adequate. A more sophisticated hydrostatic type testing device did not yield more consistent or uniform test data.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Fabrication and Testing of 105 mm Sintered Iron Rotating Bands


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Zaleski, F.I. (Autor:in)

    Kongress:

    1969 International Automotive Engineering Congress and Exposition ; 1969



    Erscheinungsdatum :

    01.02.1969




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Sintered iron shell rotating bands

    Krebs, Heinrich L. | TIBKAT | 1947



    Surface melting of rotating bands

    Montgomery, R. | Tema Archiv | 1976


    Projectile lubrication by melting rotating bands

    Montgomery, R. | Tema Archiv | 1976


    Heat generation and friction in rotating bands

    Ettles, C.M.McC. | Tema Archiv | 1986