This Aerospace Recommended Practice (ARP) describes methods of vacuum bagging, a process used to apply pressure in adhesive bonding and heat curing of thermosetting composite materials and metalbond for commercial aircraft parts. If this document is used for the vacuum bagging of other than thermosetting composite materials and metalbond, the fitness for this purpose must be determined by the user. The methods shall only be used when specified in an approved Repair Document or with the agreement of the Original Equipment Manufacturer (OEM). Introduction of bagging for metalbond repair. ARP5143A has been reaffirmed to comply with the SAE Five-Year Review policy.
Vacuum Bagging of Thermosetting Composite and Metalbond Repairs
14.08.2023
Aufsatz (Konferenz)
Englisch
Vacuum Bagging of Thermosetting Composite Repairs
SAE Technical Papers | 2011
Knife-edge seal for vacuum bagging
NTRS | 1980
|Vacuum Bagging: Fiberglass Parts Fabrication with Quality
SAE Technical Papers | 2006
|Sensor-based leakage detection in vacuum bagging
Deutsches Zentrum für Luft- und Raumfahrt (DLR) | 2021
|