Reliable means for on-board detection of particulate filter failures or malfunctions are needed to meet diagnostics (OBD) requirements. Detecting these failures, which result in tailpipe particulate matter (PM) emissions exceeding the OBD limit, over all operating conditions is challenging. Current approaches employ differential pressure sensors and downstream PM sensors, in combination with particulate filter and engine-out soot models. These conventional monitors typically operate over narrowly-defined time windows and do not provide a direct measure of the filter’s state of health. In contrast, radio frequency (RF) sensors, which transmit a wireless signal through the filter substrate provide a direct means for interrogating the condition of the filter itself. This study investigated the use of RF sensors for the continuous measurement of filter trapping efficiency, which was compared to downstream measurements with an AVL Microsoot Sensor, and a PM sampling probe simulating the geometry and installation configuration of a conventional PM sensor. The study included several particulate filter failure modes, both above and below the OBD threshold. The results confirmed the use of RF sensors to provide a direct and continuous measure of the particulate filter’s state of health over a range of typical in-use operating conditions, thereby significantly increasing the time window over which filter failures may be detected.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Continuous Particulate Filter State of Health Monitoring Using Radio Frequency Sensing


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Sappok, Alexander (Autor:in) / Herman, Andrew (Autor:in) / Parks, James (Autor:in) / Storey, John (Autor:in) / Bromberg, Leslie (Autor:in) / Ragaller, Paul (Autor:in) / Prikhodko, Vitaly (Autor:in)

    Kongress:

    WCX World Congress Experience ; 2018



    Erscheinungsdatum :

    2018-04-03




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    On-Board Particulate Filter Failure Prevention and Failure Diagnostics Using Radio Frequency Sensing

    Sappok, Alexander / Herman, Andrew / Parks, James et al. | SAE Technical Papers | 2017


    Particulate Filter Soot Load Measurements using Radio Frequency Sensors and Potential for Improved Filter Management

    Sappok, Alexander / Warkins, Jason / Bromberg, Leslie et al. | SAE Technical Papers | 2016


    Loading and Regeneration Analysis of a Diesel Particulate Filter with a Radio Frequency-Based Sensor

    Sappok, Alexander / Parks, James E. / Bromberg, Leslie et al. | SAE Technical Papers | 2010


    Loading and regeneration analysis of a diesel particulate filter with a radio frequency-based sensor

    Sappok,A. / Bromberg,L. / Parks,J.E. et al. | Kraftfahrwesen | 2010