Square punch/open die experiments were conducted to study the stretch forming of full-width blanks and plane strain strips. In order to measure bending effects, strains on both surfaces of the sheets were measured for three punch profile radii, using circle grids with 1.27 mm diameter. Two rigid-viscoplastic finite element programs, SHEET-S and SHEET-3, were used to predict plane-strain and 3-D strain distributions. The numerical results were compared with experimental data and good agreement was observed. It was found that the section analysis approach may be valid for a wide range of applications not strictly meeting the plane strain conditions, such as the biaxial stretch case. The bending effect is studied and a geometrical correction of the membrane FEM predictions, through t/2r, was introduced. The membrane section analysis program agreed well with measurements for r/t ( radius of curvature/sheet thickness ) values greater than 3 and when compound curvature was not present. For scan lines over corners with compound curvatures, 3-D membrane FEM was found to be more suitable than the section analysis.
Square Punch Forming: Section Analysis and Bending Study
Sae Technical Papers
International Congress & Exposition ; 1991
1991-02-01
Aufsatz (Konferenz)
Englisch
Square punch forming:section analysis and bending study
Kraftfahrwesen | 1991
|Study on Metal Sheet Ductile Fracture using Square Punch Test
SAE Technical Papers | 2018
|High-strength steel punch forming reel pipe torsion beam
Europäisches Patentamt | 2021
|Study on bending collapse of square and cylindrical tubes
British Library Conference Proceedings | 2007
|