Ported shroud compressor covers recirculate low momentum air near the inducer blade tips, and the use of these devices has traditionally been confined to extending the low-flow operating region at elevated rotational speeds for compressors on compression-ignition (CI) engines. Implementation of ported shrouds on compressors for spark-ignition (SI) engines has been generally avoided due to operation at pressure ratios below the region where ported shrouds improve low-flow range, the slight efficiency penalty, and the perception of increased noise. The present study provides an experimental investigation of performance and acoustics for a SI engine turbocharger compressor both with a ported shroud and without (baseline). The objective of implementing the ported shroud was to reduce mid-flow range broadband whoosh noise of the baseline compressor over 4-12 kHz. At the compressor inlet, elevated BPF noise of the ported shroud partially offset the mid-flow range (4-12 kHz) whoosh noise suppression and the maximum overall SPL reduction was 6 dB(A), while elevated 4-12 kHz and BPF noise caused an SPL increase of up to 5 dB(A) at low speed and flow. Since the ported shroud did not significantly increase low-flow 4-12 kHz noise at the compressor outlet, overall SPL was reduced over the mid to low flow range by a maximum of 12 dB(A).


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    The Effect of Ported Shroud Recirculating Casing Treatment on Turbocharger Centrifugal Compressor Acoustics


    Weitere Titelangaben:

    Sae Int. J. Engines


    Beteiligte:
    Selamet, Ahmet (Autor:in) / Karim, Ahsanul (Autor:in) / Miazgowicz, Keith (Autor:in) / Steiger, Michael (Autor:in) / Dehner, Rick D. (Autor:in)

    Kongress:

    Noise and Vibration Conference and Exhibition ; 2017


    Erschienen in:

    Erscheinungsdatum :

    2017-06-05


    Format / Umfang :

    10 pages




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch






    Dynamic Characterization of a Centrifugal Compressor with Ported Shroud

    Gancedo, Matthieu / Guillou, Erwann / DiMicco, Russell et al. | AIAA | 2011



    Numerical Flow Analysis of a Centrifugal Compressor with Ported and without Ported Shroud

    Semlitsch, Bernhard / Gutmark, Ephraim / V, JyothishKumar et al. | SAE Technical Papers | 2014