Combustion and emission characteristics of diesel and biodiesel blends (soybean methyl ester) were studied in a single-cylinder Direct Injection (DI) engine at different loads and a constant speed. The results show that NOx emission and fuel consumption are increased with increasing biodiesel percentage. Reduction of smoke opacity is significant at higher loads with a higher biodiesel ratio. Compared with the baseline diesel fuel, B20 (20% biodiesel) has a slight increase of NOx emission and similar fuel consumption. Smoke emission of B20 is close to that of diesel fuel. Results of combustion analysis indicate that start of combustion (SOC) for biodiesel blends is earlier than that for diesel. Higher biodiesel percentage results in earlier SOC. Earlier SOC for biodiesel blends is due to advanced injection timing from higher density and bulk modulus and lower ignition delay from higher cetane number. Peak of heat release rate (PHRR) of biodiesel blends is further decreased with increasing the biodiesel percentage, which is due to poor evaporation and atomization characteristics of biodiesel blends and lower ignition delay from higher CN (Cetane Number). Additionally, hot Exhaust Gas Recirculation (EGR) will significantly decrease the NOx emission for diesel and biodiesel blends. NOx emission of pure biodiesel is lower than baseline of diesel at about 10% EGR rate. However, EGR rates have little influence on the peak of heat release rate for pure biodiesel.
Characteristics of Combustion and Emissions in a DI Engine Fueled with Biodiesel Blends from Soybean Oil
Sae Technical Papers
2008 SAE International Powertrains, Fuels and Lubricants Congress ; 2008
2008-06-23
Aufsatz (Konferenz)
Englisch
British Library Conference Proceedings | 2008
|Reducing NOx Emissions from a Common-Rail Engine Fueled with Soybean Biodiesel
SAE Technical Papers | 2011
|Reducing NOx Emissions from a Common-Rail Engine Fueled with Soybean Biodiesel
British Library Conference Proceedings | 2011
|SAE Technical Papers | 2013
|