The first reinforced high density polyethylene blow molding compound with engineering properties has been developed by Phillips Chemical Company in a two-year joint program with Fisher Body Division of General Motors and Ford Motor Company. Chemically coupled mica, compounded with a Marlex ® high molecular weight high density polyethylene copolymer, results in a material having dramatically improved stiffness at both room temperature and elevated (180°F) temperatures.The high rigidity of this material has allowed reduced piece weight and significant cost savings in three automotive seat back panel and load floor applications. A full width seat back weighing about half of a metal frame is now being used in the Chevrolet Camaro, Chevrolet Z28 and Pontiac Firebird. A split seat back version is standard in the Pontiac Trans Am. Ford has realized impressive cost savings using a large mica reinforced high density polyethylene load floor in their Escort EXP and Lynx LN7 cars. The success of these blow molded applications has spawned promising development work in thermoforming and sheet compression molding processes.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Blow Molded Reinforced High Density Polyethylene for Structural Applications


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Peters, D. L (Autor:in) / Hughes, J. K. (Autor:in) / Kowalski, R. C. (Autor:in)

    Kongress:

    SAE International Congress and Exposition ; 1983



    Erscheinungsdatum :

    01.02.1983




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Blow Molded Reinforced High Density Polyethylene for Structural Applications

    Peters,D.L. / Kawalski,R.C. / Hughes,J.K. et al. | Kraftfahrwesen | 1983


    Blow-molded foam

    ONODERA MASAAKI / SUMI TAKEHIKO / TAMADA TERUO et al. | Europäisches Patentamt | 2021

    Freier Zugriff

    BLOW MOLDED PRODUCT

    ICHIBOSHI HIROKI | Europäisches Patentamt | 2016

    Freier Zugriff

    BLOW MOLDED PRODUCT

    LEE SOO KYEONG / RYOO SEUNG CHEOL / KIM SEONG LYONG | Europäisches Patentamt | 2019

    Freier Zugriff

    BLOW-MOLDED FOAM

    ONODERA MASAAKI / SUMI TAKEHIKO / TAMADA TERUO et al. | Europäisches Patentamt | 2019

    Freier Zugriff