This SAE Standard specifies dimensions and requirements for single-wall steel tubing intended for use as high-pressure fuel injection pipes on a wide range of engines (Class A), and for fuel injection pump testing (Class B, Reference SAE J1418). Tubing shall be cold drawn, annealed or normalized, seamless tubing suitable for cold swaging, cold upsetting, and cold bending.SAE J1958 has been cancelled because the content of this standard is fully covered by ISO 8535-1. Therefore, to eliminate such redundancy and confusion in coordinating the standards between ISO and SAE, this document is declared cancelled and superseded by ISO 8535-1.
Diesel Engines - Steel Tubes for High-Pressure Fuel Injection Pipes (Tubing)
24.11.2015
Aufsatz (Konferenz)
Englisch
DIESEL ENGINES—STEEL TUBES FOR HIGH-PRESSURE FUEL INJECTION PIPES (TUBING)
SAE Technical Papers | 1995
Diesel Engines—Steel Tubes for High-Pressure Fuel Injection Pipes (Tubing)
SAE Technical Papers | 2002
DIESEL ENGINES - STEEL TUBES FOR HIGH PRESSURE FUEL INJECTION PIPES (TUBING)
SAE Technical Papers | 1989
Fuel Injection Pumps—High Pressure Pipes (Tubing) for Testing
SAE Technical Papers | 2002
FUEL INJECTION PUMPS—HIGH PRESSURE PIPES (TUBING) FOR TESTING
SAE Technical Papers | 1995