A significant fraction of hydrocarbon (HC) emissions occurs during the cold-start phase of an engine's operating cycle. Fuel drop sizes in the cylinder and impingement of fuel on the cylinder wall are two factors which can affect the HC emissions during this period. Therefore, measurements of in-cylinder drop sizes and wall fuel impingement were made on a steady flow bench at flow rates and manifold vacuum conditions which simulated desired engine operating conditions. Experimental variables included three injector types, two cylinder head geometries, three valve lifts, and two simulated engine speeds.Injector performance was assessed prior to the flow bench studies. Fuel injector performance was found to affect in-cylinder drop size and wall fuel impingement. The dual-jet injector produced two liquid streams which were not atomized into drops at a distance of 10 cm (a typical injector to valve distance) from the injector tip. The pintle and air-assist injectors produced finer sprays with line-of-sight Sauter Mean Diameters (SMD's) of 119 μm and 39 μm, respectively. SMD's in the cylinder ranged from 15 to 140 μm for the dual-jet injector and from 15 to 70 μm for the pintle injector. With the air assist injector, which produced the smallest line-of sight SMD, the SMD's in the cylinder ranged from 5 to 20 μm and cylinder wall impingement was only a third to half as much as impingement with the pintle or dual-jet injector.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    In-Cylinder Fuel Drop Size and Wall Impingement Measurements


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    DeYoung, C. A. (Autor:in) / Peters, J. E. (Autor:in) / Kelly-Zion, P. L. (Autor:in) / White, R. A. (Autor:in)

    Kongress:

    1995 SAE International Fall Fuels and Lubricants Meeting and Exhibition ; 1995



    Erscheinungsdatum :

    1995-10-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Fuel Deposition on Wall Impingement of a Spray

    Obermeier, F. / Chaves, H. / Möller, Thorsten J. | SAE Technical Papers | 1996


    Diesel spray and adhering fuel on an impingement wall

    Ko,K. / Arai,M. / Gunma Univ.,JP | Kraftfahrwesen | 2002


    Impingement and Adhesion on Cylinder Liners with Post Diesel Fuel Injections

    Sha, Fukei / Shibata, Gen / Ogawa, Hideyuki et al. | SAE Technical Papers | 2016


    Impingement and Adhesion on Cylinder Liners with Post Diesel Fuel Injections

    Shibata, Gen / Ogawa, Hideyuki / Sha, Fukei et al. | British Library Conference Proceedings | 2016


    Diesel Spray and Adhering Fuel on an Impingement Wall

    Ko, Kyungnam / Arai, Masataka | SAE Technical Papers | 2002