This paper presents the discussion of the optimal shape for the wire cross section of helical springs. Since the stress at the inner side of a coil is higher than that at the outer side in a helical spring with a round cross section, the mass may be saved through stress equalization by the improvement of the cross sectional shape. Shape optimization is performed by the modification of the cross sectional shape so as to minimize the mass of the helical spring under constraints such as spring rate, coil diameter, applied load and maximum design stress.In the present analysis, stress distributions are calculated by the finite element analysis based on a stress function. In consequence, the optimized shapes are found to be almost oval and the mass is reduced by about 10% for the springs of small spring index.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Shape Optimization of the Wire Cross Section of Helical Springs


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    International Congress & Exposition ; 1992



    Erscheinungsdatum :

    1992-02-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Shape optimization of the wire cross section of helical springs

    Imaizumi,T. / Ohkouchi,T. / Ichikawa,S. et al. | Kraftfahrwesen | 1992



    Helical springs

    Dick, J. | Engineering Index Backfile | 1946


    Design and Testing of Ovate Wire Helical Springs

    Yamamoto, Hideo / Saitoh, Kunishige / Miyamura, Noriyuki et al. | SAE Technical Papers | 1993


    Design and testing of ovate wire helical springs

    Miyamura,N. / Kunou,T. / Saitoh,K. et al. | Kraftfahrwesen | 1993