Imposing tensile stress on an edge of a sheet metal blank is a common condition in many sheet metal forming operations, making edge formability a very important factor to consider. Because edge formability varies greatly among different materials, cutting methods (and their control parameters), it is very important to have access to an experimental technique that would allow for quick and reliable evaluation of edge formability for a given case. In this paper, two existing techniques are compared: the hole expansion test and the tensile test. It is shown that the hole expansion test might not be adequate for many cases, and is prone to overestimating the limiting strain, because the burr on the sheared edge is typically smaller than what is observed in production. The tensile test represents an effective alternative to the hole expansion test. Advantages and disadvantages of each case are discussed. Additionally, the strain gradient effect in the hole expansion test is investigated by means of finite element analysis.
Analysis of Methods for Determining Sheared Edge Formability
Sae Technical Papers
SAE 2011 World Congress & Exhibition ; 2011
2011-04-12
Aufsatz (Konferenz)
Englisch
Analysis of Methods for Determining Sheared Edge Formability
British Library Conference Proceedings | 2011
|On Formability Limitations in Stamping Involving Sheared Edge Stretching
SAE Technical Papers | 2007
|On formability limitations in stamping involving sheared edge stretching
Kraftfahrwesen | 2007
|On Formability Limitations in Stamping Involving Sheared Edge Stretching
British Library Conference Proceedings | 2007
|CAE Analysis Approach for Split on Stamping Edge Considering Sheared Edge Effect
Tema Archiv | 2009
|