This paper describes a series of vehicle emission tests on a port-fuel injected lean-burn engine, to determine the preferred aftertreatment configuration yielding the most efficient regeneration of a lean-NOx trap (LNT). Three configurations were tested: (A) single starter three-way catalyst (TWC) upstream of an underfloor LNT; (B) bifurcated system with short downpipes comprising parallel TWCs upstream of a single underfloor LNT (Y-pipe configuration); and (C) bifurcated system with extended downpipes. System ‘A’ exhibits satisfactory LNT regeneration behaviour, and is within the European Stage III limits after accelerated aging. Results for system ‘B’, with identical TWC and LNT formulations as the single system, show that this LNT cannot be adequately regenerated under standard purge conditions; even with a fresh trap. In this non-optimized bifurcated system, the AFR profile entering the LNT during the rich purge deviates markedly from that requested by the calibration. A change in TWC formulation to one with different oxygen storage characteristics demonstrates that this system can perform satisfactory in the bifurcated configuration. Further tests on system ‘C’ with: (1) uncoated TWC substrates; and (2) the original TWC formulation, indicate that LNT regeneration efficiency in a bifurcated system is dependent upon the TWC formulation in conjunction with oscillatory flow in the Y-pipe. Implications of these results are discussed in terms of future direct injection gasoline engine programs.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Optimising the Aftertreatment Configuration for NOx Regeneration on a Lean-NOx Trap


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Eves, B. (Autor:in) / Gregory, D. (Autor:in) / Peirce, G. (Autor:in) / Hepburn, J. (Autor:in) / Dearth, M. (Autor:in) / Marshall, R. A. (Autor:in) / Cornish, S. (Autor:in) / Taylor, T. (Autor:in)

    Kongress:

    International Fuels & Lubricants Meeting & Exposition ; 1999



    Erscheinungsdatum :

    1999-10-25




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Optimising the aftertreatment configuration for NOx regeneration on a lean-NOx trap

    Marshall,R.A. / Gregory,D. / Eves,B. et al. | Kraftfahrwesen | 1999


    Spray Modeling for Lean NOx Trap Aftertreatment System Design

    McCarthy, Jr., James / Mohanta, Lokanath / Kulkarni, Milind S | SAE Technical Papers | 2009


    Lean NOx Trap Aftertreatment Technology Impact on Engine Oil Dilution

    Chianale, A. / Leo, A. / Senatore, A. et al. | SAE Technical Papers | 2009


    Lean Gasoline Engine Reductant Chemistry During Lean NOx Trap Regeneration

    Choi, Jae-Soon / Parks, James E. / Norman, Kevin et al. | SAE Technical Papers | 2010


    Dual SCR aftertreatment for lean NOx reduction

    DiMaggio,C.L. / Fisher,G.B. / Rahmoeller,K.M. et al. | Kraftfahrwesen | 2009