Studying the reactions in an automotive exhaust catalyst is complex as the exhaust gases contain many components of which the composition constantly varies and the catalyst contains different active components. To elucidate reaction kinetics in exhaust catalysis, the application of a technique stemming from nuclear medicine, i.e. Positron Emission Tomography, has been developed.Short lived positron emitting nuclides 11C (t1/2 = 20 min), 13N (t1/2 = 10 min) and 15O (t1/2 = 2 min) have been used to synthesise actual reactant molecules such as 11CO, 11CO2, 11CH4, 13N2, 15OO, C15O and C15OO. Pulses of picomole amounts of these labelled reactants have been added to synthetic exhaust gases, which were led over commercial and model automotive catalysts in a small plug flow reactor. The labelled compounds were detected and identified in both reactant and product stream using a gas chromatograph equipped with a proportional counter. On top of that, the labelled reactants in the catalyst bed could be monitored right through the reactor wall using a Positron Emission Tomograph, with a resolution of 1 cm in place and 1 s in time. Hereby, a large amount of information on the residence time of the reactants is obtained directly from the catalyst surface under actual reaction conditions.By means of these experiments the rate limiting step in the carbon monoxide oxidation on platinum and rhodium under cold start conditions of a car were found to be the availability of free noble metal surface for the dissociative oxygen adsorption. The different behaviour of rhodium and platinum in the CO oxidation in the presence of NO was found to be the higher tendency for NO dissociation of rhodium. A strong interaction was found between gas phase CO2 and CeO2 at the catalyst surface, whereby the oxygen atoms contained in lattice CeO2 exchange rapidly with the oxygen atoms of the adsorbed CO2. A mathematical model for the reaction kinetics was constructed and by simulating the experiments with this model the kinetic parameters were quantified.The experiments demonstrate the utility of short-lived positron emitter nuclides such as 11C, 13N and 15O, for non-invasive and in-situ catalyst research. The importance of using in-situ catalyst surface information in understanding the working of automotive exhaust catalysts under actual reaction conditions is emphasised.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Studies to the Functioning of Automotive Exhaust Catalysts Using In-Situ Positron Emission Tomography


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Jonkers, G. (Autor:in) / Vonkeman, K.A. (Autor:in) / van Santen, R.A. (Autor:in)

    Kongress:

    International Congress & Exposition ; 1991



    Erscheinungsdatum :

    1991-02-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Studies to the functioning of automotive exhaust catalyst using in-situ Positron Emission Tomography

    Vonkeman,K.A. / Jonkers,G. / Santen,R.A.van et al. | Kraftfahrwesen | 1991


    Numerical modeling of automotive exhaust catalysts

    Kato,M. / Matsummoto,T. / Otsuka,S. et al. | Kraftfahrwesen | 2011


    Numerical Modeling of Automotive Exhaust Catalysts

    Okubo, Hirosuke / Kato, Masayuki / Otsuka, Shinichiro et al. | SAE Technical Papers | 2011


    Use of high cell density monolithic catalysts for automotive exhaust emission control

    Katajima,T. / Chiku,T. / Shirakura,Y. et al. | Kraftfahrwesen | 1982


    Use of High Cell Density Monolithic Catalysts for Automotive Exhaust Emission Control

    Yamada, Masayoshi / Kitajima, Tadashi / Chiku, Takahiro et al. | SAE Technical Papers | 1982