Semi-premixed diesel combustion with a twin peak shaped heat release with the two-stage fuel injection (twin combustion) has the potential to establish efficient, low emission, and low noise operation. However, with twin combustion at low loads the indicated thermal efficiencies are poorer than at medium loads due to the lower combustion efficiencies. In this report, to increase the combustion efficiencies at low loads, the thermal efficiency related parameters were investigated in a 0.55 L single cylinder diesel engine. The results show that the indicated thermal efficiency improves with increases in the intake gas temperatures at low loads. However, at the higher loads where the combustion efficiencies are somewhat higher the indicated thermal efficiencies decrease with increases in the intake gas temperatures due to increases in the cooling losses. At the low load condition below 300 kPa IMEP, the indicated thermal efficiency is higher and the combustion noise is lower in the twin combustion than in the single premixed combustion. Further, the combustion characteristics of twin and single premixed diesel combustion at low loads were analyzed with CFD simulation, showing that in the twin combustion, re-oxidation of the CO is promoted by the second-stage combustion and the indicated thermal efficiencies are higher than in the single premixed combustion due to higher combustion efficiencies. Both the heat flux value and the high heat flux area in the twin combustion are smaller than in the single premixed combustion due to decreases in the quantities of burned gas near the combustion chamber wall due to the separating of the fuel injections.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Thermal Efficiency Improvement and its Mechanism at Low Load Conditions in Semi-Premixed Diesel Combustion with Twin Peak Shaped Heat Release


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Shibata, Gen (Autor:in) / Ogawa, Hideyuki (Autor:in) / Inaba, Kazuki (Autor:in) / Zhang, Yanhe (Autor:in) / Kobashi, Yoshimitsu (Autor:in) / Masuko, Yosuke (Autor:in)

    Kongress:

    WCX SAE World Congress Experience ; 2019



    Erscheinungsdatum :

    2019-04-02




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Semi-Premixed Diesel Combustion with Twin Peak Shaped Heat Release Using Two-Stage Fuel Injection

    Shibata, Gen / Ogawa, Hideyuki / Obe, Tatstunori et al. | SAE Technical Papers | 2016



    Combustion modeling of diesel combustion with partially premixed conditions

    Hu,B. / Jhavar,R. / Singh,S. et al. | Kraftfahrwesen | 2007


    Combustion Modeling of Diesel Combustion with Partially Premixed Conditions

    Hu, Bing / Rutland, Christopher J. / Jhavar, Rahul et al. | SAE Technical Papers | 2007