This specification covers the requirements for producing brazed joints of aluminum and aluminum alloys by immersion in a molten flux bath. AMS2673F results from a Five-Year Review and update of this specification with the addition of ordering information, added reference to destructive testing to coverage (3.6.2), reworded and clarified chlorides (3.6.5.1) and fluorides (3.6.5.2) to state the same requirements as in AMS2472, changed flux removal to halide test in acceptance tests (4.2.1), deleted destructive coverage test from periodic testing (4.2.2) as it is a required acceptance test, added suspension of periodic testing per general agreement, added note 2 to Table 1 sampling for acceptance testing that requires sampling to be agreed upon when lot sizes are less than 40, and revised dimensions and properties statement to reflect that some SI units are primary (8.4).
Brazing, Aluminum and Aluminum Alloys Molten Flux (Dip)
2022-08-19
Aufsatz (Konferenz)
Englisch
Brazing, Aluminum and Aluminum Alloys Molten Flux (Dip)
SAE Technical Papers | 2006
BRAZING, ALUMINUM AND ALUMINUM ALLOYS MOLTEN FLUX (DIP)
SAE Technical Papers | 1995
Brazing, Aluminum and Aluminum Alloys Molten Flux (Dip)
SAE Technical Papers | 2018
ALUMINUM MOLTEN FLUX (DIP) BRAZING
SAE Technical Papers | 1991
ALUMINUM MOLTEN FLUX (DIP) BRAZING
SAE Technical Papers | 1968