The paper proposes a performance prediction method at design and off design values of mass rate and rotational speed for a low pressure ratio (2.2:1) centrifugal compressor capable of rotating at speeds up to 90000 r.p.m. The procedure employed consists of combining selected losses obtained from semi-empirical equations to construct an overall picture of efficiency of the compression process. The estimated performance of a radial centrifugal compressor with splitter blades was compared with experimental results covering wide range of the performance map, the achieved level of agreement was approximately within 4% from measurements. It should be mentioned however that the proposed method does not describe the internal aerodynamic effects occuring, it does however isolate some important variables and then relate them to the total pressure loss across the stage.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Performance Prediction Method for Low Pressure Ratio Centrifugal Compressor


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Dahgan, Mahdi (Autor:in) / Al-Zubaidy, Sarim (Autor:in)

    Kongress:

    International Off-Highway & Powerplant Congress & Exposition ; 1992



    Erscheinungsdatum :

    1992-09-01




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Performance Prediction Method for Low Pressure Ratio Centrifugal Compressor

    Al-Zubaidy,S. / Dahgan,M. / United Arab Emirates Univ.,AE | Kraftfahrwesen | 1992


    Performance improvement of a high pressure ratio centrifugal compressor by integrated cooling

    Mostafa Moosania, Seyed / Zheng, Xinqian | SAGE Publications | 2016



    18:1 pressure ratio axial/centrifugal compressor demonstration program

    SCHWEITZER, J. K. / FAIRBANKS, J. W. | AIAA | 1983