Reed valves are the most common method used to control the intake of fresh air and fuel into the crankcase of a high performance two-stroke engine. While they can be quite simple in terms of mechanical design, their operation is highly dynamic and can be influenced by many other components.Previous publications from The Queen's University of Belfast have shown the derivation of mathematical models and their verification by measurements from a firing engine at relatively high engine speeds, up to 9,500 rev/min.In this present paper, measured and predicted data for delivery ratio and reed tip lift are presented for a 125 cm3, single cylinder engine over a range of speeds up to 12,290 rev/min. Steady flow discharge coefficients are measured and used in the mathematical simulation. Four variations of reed valve material/thickness are investigated in the firing engine. Correlation between measured and predicted delivery ratio is good over the speed range and various reed specifications. Correlation for reed tip lift behaviour is reasonably good, considering the highly dynamic operating conditions. Overall, the enhanced simulation model can be used to determine an optimised reed specification with a high level of confidence.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Mathematical Modelling of Reed Valve Behaviour in High Speed Two-Stroke Engines


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    1997 SAE International Off-Highway and Powerplant Congress and Exposition ; 1997



    Erscheinungsdatum :

    1997-09-08




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Mathematical modelling of reed valve behavior in high speed two-stroke engines

    Fleck,R. / Cartwright,A. / Thornhill,D. et al. | Kraftfahrwesen | 1997


    An improved model for predicting reed valve behaviour in two-stroke cycle engines

    Fleck,R. / Blair,G.P. / Houston,R.A. et al. | Kraftfahrwesen | 1987


    An Improved Model for Predicting Reed Valve Behaviour in Two-Stroke Cycle Engines

    Blair, G. P. / Fleck, R. / Houston, R. A. R. | SAE Technical Papers | 1987


    An improved model for predicting reed valve behaviour in two-stroke cycle engines

    Fleck, R. / Blair, G.P. / Houston, R.A. | Tema Archiv | 1987


    Development of a reed valve model for engine simulations for two-stroke engines

    Dave,A. / Siddiqui,A. / Probst,D. et al. | Kraftfahrwesen | 2004