The Porsche 1:4-scale model wind tunnel was upgraded with a moving belt in combination with basic and distributed boundary layer suction devices. The belt is placed between the rotating wheels of the model with the external underfloor balance in operation. Special attention was given to providing a sufficient length of the belt with regard to road simulation for the aerodynamic optimization of race car models with their specific wake behavior. The boundary layer suction systems control the regions beyond the belt. Furthermore the balance was equipped with a pitch angle adjustment system in order to simulate the spring deflections of a moving vehicle.Results from a series of measurements taken from one race car model and one passenger car model are presented in order to investigate the influence of the boundary layer-, wheel rotation- and pitch adjustment-controls on the characteristic aerodynamic figures of the models.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Moving Belt with Distributed Suction in the Porsche Model Wind Tunnel


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:
    Singer, Norbert (Autor:in) / Mueller, Reiner (Autor:in) / Eckert, Winfried (Autor:in)

    Kongress:

    International Congress & Exposition ; 1999



    Erscheinungsdatum :

    01.03.1999




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Moving Belt with Distributed Suction in the Porsche Model Wind Tunnel

    Mueller, R. / Singer, N. / Eckert, W. et al. | British Library Conference Proceedings | 1999


    Moving belt with distributed suction in the Porsche model wind tunnel

    Mueller,R. / Singer,N. / Eckert,W. et al. | Kraftfahrwesen | 1999




    Full-scale moving belt in Fiat aerodynamic wind tunnel

    Berta,C. / Fiat,Turin,IT | Kraftfahrwesen | 1990