In case of cooling module rotated by belt, many sources (vehicle’s vibration, belt’s tension and thrust force by rotated fan) are acting on it. Because it is not easy to analyze them individually, there were no rig test modes for pre-validation while developing a new vehicle.In this study, we correlated the strain gauges signal to belt’s tension and fan’s thrust force, and measured acceleration of a vehicle and cooling module by driving a vehicle on the several test roads. In that case of measured acceleration data, we could analyze it by using PDF and construct the representative rig test modes considering vibrational fatigue characteristics by using the FDS. These modes can be utilized while developing a new vehicle without measuring anymore.Also, we could understand each load’s characteristics. It is confirmed that the factors affecting the fatigue were not only the vehicle’s vibration but also the belt’s installation tension. So it needs to add belt’s installation tension as a static load condition for rig test. Since the domain frequency range of tension and thrust force while driving is lower than 2 Hz, the fatigue caused by tension and thrust force is not suitable by vibration rig test. This is because the minimum frequency applied by the actual vibration tester is from 5 Hz. So we realize that rig modes must contain not only the vibrational fatigue test but also static fatigue test. Another outcome is making fixture for testing the rig test modes, the fixture must have sufficient compliance to reduce the energy loss from actuator to cooling module. And the fixture must be compatible to allow easy installation of different cooling modules.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Development of a Pre-Validation Mode for Cooling Module by Test and CAE


    Weitere Titelangaben:

    Sae Technical Papers


    Beteiligte:

    Kongress:

    WCX World Congress Experience ; 2018



    Erscheinungsdatum :

    2018-04-03




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Electronic Cooling Design and Test Validation

    Murtha, William B. | SAE Technical Papers | 1983


    Multi mode clutch module development

    Papania,J.R. / Borg Warner,US | Kraftfahrwesen | 2014


    Multi-Mode Clutch Module Development

    Papania, James R. | Tema Archiv | 2014


    Cooling module

    Europäisches Patentamt | 2022

    Freier Zugriff

    COOLING MODULE

    YUN SHIN-WON / KIM HYUK / KIM JAE YONG et al. | Europäisches Patentamt | 2016

    Freier Zugriff