Abstract Transformation-induced plasticity (TRIP) steels are part of advanced high strength steels capable of phase transformation, having good strength and ductility. The transformation rate is known to be dependent on the stress state, which may lead to asymmetric hardening behaviour for TRIP steels with compressive flow stresses larger than tensile ones. Sheet stamping products of TRIP steels show complex springback because of the asymmetry in addition to the large strength, which will complicate the analysis of sheet metal forming processes. In this work, the asymmetric hardening behaviour of a TRIP steel with a tensile strength of 1180 MPa was measured using the sheet tension-compression tester. An asymmetric hardening model was developed by introducing an off-centred bounding surface for the kinematic back-stress evolution, to depict the asymmetric hardening behaviour. The model parameters of the proposed constitutive equations were obtained from the stressstrain curves under tension followed by compression. The stress-strain curves were well captured by the developed constitutive model, whereas the conventional symmetric model fails to describe the asymmetric hardening behaviour of the TRIP steel. For validation, load-displacement curve and springback angles of three-point bending test were compared with the predictions by the proposed model.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Constitutive Modeling of Asymmetric Hardening Behavior of Transformation-Induced Plasticity Steels


    Beteiligte:
    Jung, Jaebong (Autor:in) / Hur, Yong Chan (Autor:in) / Jun, Sungwook (Autor:in) / Lee, Hyun-Seok (Autor:in) / Kim, Byung-Min (Autor:in) / Kim, Ji Hoon (Autor:in)


    Erscheinungsdatum :

    2019




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch


    Klassifikation :

    BKL:    55.20$jStraßenfahrzeugtechnik / 55.20 Straßenfahrzeugtechnik



    Constitutive Modeling of Asymmetric Hardening Behavior of Transformation-Induced Plasticity Steels

    Jung, Jaebong / Hur, Yong Chan / Jun, Sungwook et al. | Springer Verlag | 2019



    Plasticity constitutive modeling of partially confined concrete with steel jacketing

    Shafei, Erfan / Rahmdel, Javad Mokari | Online Contents | 2017


    Constitutive Modeling of Multi-Functional Structural Energetic Materials: Plasticity Effects

    Reding, Derek / Lu, Xia / Narayanan, Vindhya et al. | AIAA | 2006


    Plasticity constitutive modeling of partially confined concrete with steel jacketing

    Shafei, Erfan / Rahmdel, Javad Mokari | Springer Verlag | 2017