Abstract Wall wetting in the early injection period has been proved to be unavoidable in the HCCI (Homogeneous charge compression ignition) diesel engine using early injection strategy, which directly affects in-cylinder fuel-air mixture formation. In this study, the effects of the early injection parameters (injection timing, injection angle and injection pressure) on wall wetting characteristics of an HCCI diesel engine using early injection strategy have been numerically investigated. The variations of maximum wall film mass, evaporated wall film mass and residual wall film mass have been summarized. The concept of MHI (Mixture Homogenous Index) is introduced to evaluate the homogeneity of fuel-air mixture in the wall wetting region. In additions, the effects of the early injection parameters on the HC (Hydrocarbon Compounds) and CO (Carbon Monoxide) emissions have also been discussed. Results showed that in order to decrease the HC and CO emission caused by wall wetting as low as possible, it was better to increase the injection pressure and to advance the injection timing. The most effective method was to narrow the injection angle, In addition, the impingement target should be considered for choosing the injection timing and injection angle, and the impingement target of the piston bowl lip was recommended due to the enhancement of the atomization and the higher surface temperature.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Numerical study of the early injection parameters on wall wetting characteristics of an HCCI diesel engine using early injection strategy


    Beteiligte:
    Yu, Hanzhengnan (Autor:in) / Liang, Xingyu (Autor:in) / Shu, Gequn (Autor:in)


    Erscheinungsdatum :

    2017




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch



    Klassifikation :

    BKL:    55.20$jStraßenfahrzeugtechnik / 55.20 Straßenfahrzeugtechnik