In synchronous belt drives, it is generally difficult to eliminate pulley eccentricity, because the pulley teeth and shaft hole are produced separately and the pulley is installed on an eccentric shaft. This eccentricity affects the accuracy of rotation transmission, so that the belt tension changes during a single rotation of the pulley. This in turn affects the occurrence of resonance in the spans. In the present study, the transmission error in a synchronous belt drive with an eccentric pulley in the absence of a transmitted load was experimentally investigated for the case in which the spans undergo first-mode transverse vibration due to resonance. The transmission error was found to have a component with a period equal to the span displacement, in addition to a component with a period of half the span displacement. During a single rotation of the pulley, the magnitude of the transmission error increased, and its frequency decreased, with decreasing belt tension. The transmission error exhibited the large value when two frequency conditions were satisfied: one was that the meshing frequency was within the range of span frequency variations due to the eccentricity, and the other was that the minimum span frequency was close to an integer multiple of the pulley rotation frequency. Even if both of these conditions occurred, if the range of span frequency variations due to the eccentricity was larger than 13 Hz, the transmission error could be eliminated by adjusting the belt tension, so that the average span frequency corresponded to the meshing frequency.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Transmission Error Due to Resonance in Synchronous Belt Drive With Eccentric Pulley


    Beteiligte:

    Erschienen in:

    Erscheinungsdatum :

    2017




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Print


    Sprache :

    Englisch



    Klassifikation :

    BKL:    50.15 Konstruktionslehre / 52.15 Maschinenelemente, Maschinenbaugruppen / 52.20 Antriebstechnik, Getriebelehre
    Lokalklassifikation TIB:    770/5315/5330



    Pulley for use with a non-synchronous drive belt

    OSBORNE JONATHAN / LLOYD GREG | Europäisches Patentamt | 2016

    Freier Zugriff

    Accessory Drive Belt/Pulley Friction Test

    Meckstroth, Richard J. | SAE Technical Papers | 1998


    Accessory drive belt/pulley friction test

    Meckstroth,R.J. / Ford Motor,US | Kraftfahrwesen | 1998



    PULLEY WITH BELT, LIFTING STORAGE DEVICE HAVING PULLEY WITH BELT, AND MANUFACTURING METHOD OF PULLEY WITH BELT

    ICHIMARU KOTA / NAKAJIMA SATOSHI | Europäisches Patentamt | 2017

    Freier Zugriff