Soot formation process was investigated for biomass-based renewable diesel fuel, such as biomass to liquid (BTL), and conventional diesel combustion under varied fuel quantities injected into a constant volume combustion chamber. Soot measurement was implemented by two-color pyrometry under quiescent type diesel engine conditions (1000 K and 21% O2 concentration). Different fuel quantities, which correspond to different injection widths from 0.5 ms to 2 ms under constant injection pressure (1000 bar), were used to simulate different loads in engines. For a given fuel, soot temperature and KL factor show a different trend at initial stage for different fuel quantities, where a higher soot temperature can be found in a small fuel quantity case. but a higher KL factor is observed in a large fuel quantity case generally. Another difference occurs at the end of combustion due to the termination of fuel injection. Additionally, BTL flame has a lower soot temperature, especially under a larger fuel quantity (2 ms injection width). Meanwhile, average soot level is lower for BTL flame, especially under a lower fuel quantity (0.5 ms injection width). BTL shows an overall low sooting behavior with low soot temperature compared to diesel; however, trade-off between soot level and soot temperature needs to be carefully selected when different loads are used.
Effects of Fuel Quantity on Soot Formation Process for Biomass-Based Renewable Diesel Fuel Combustion
2017
Aufsatz (Zeitschrift)
Englisch
Effects of Fuel Properties on Soot Formation in Turbine Combustion
SAE Technical Papers | 1978
|Soot formation from heavy hydrocarbons representatives of diesel fuel
SAE Technical Papers | 2001
|Fuel Injection and Mean Swirl Effects on Combustion and Soot Formation in Heavy Duty Diesel Engines
SAE Technical Papers | 2007
|Distribution of Fuel Droplets, Hydrocarbon and Soot in Diesel Combustion Chamber
SAE Technical Papers | 1983
|