Standalone PhotoVoltaic System (SPVS) performance is heavily dependent on the DC-bus voltage. A robust control of the DC-bus voltage results in a good stable-working system. This paper presents a new strategy, of controlling the different elements of the system, that helps to regulate the DC-bus voltage against abrupt load variation, and keeps the system working effectively even during the lack of batteries. It uses Sliding Mode Controllers (SMC) for DC-DC converters to improve the dynamic performance of the PV system. It protects the batteries by using them only when they are needed, and therefore extends the lifetime of the installation. The system is designed to supply both DC and AC loads in remote sites where no grid utility is available. It is composed of three photovoltaic arrays, a bank of batteries, a set of DC-DC and DC-AC converters, and DC/AC loads. The operations of the system are categorized into 04 modes, and their selection depends on the supply and demand of energy on one side, and the state of charge of the batteries on the other. The system is modeled and simulated in Simulink environment. Tests are done under very hard and quick variations of load, and results bear witness to the robustness of the controllers and to the high performance of the system as well.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren




    Mobile Standalone Photovoltaic Device

    LEE CHANG GEUN / RYU YOUNG OK / LEE JI EUN et al. | Europäisches Patentamt | 2018

    Freier Zugriff

    Mobile Standalone Photovoltaic Device

    Europäisches Patentamt | 2022

    Freier Zugriff