Highly loaded composite struts from a proposed truss-based Altair lunar lander descent stage concept were selected for development under NASA's Advanced Composites Technology program. Predicted compressive member forces during launch and ascent of over -100,000 lbs were much greater than the tensile loads. The development of a capability for experimental evaluation of the structural performance of these struts is presented. Strut lengths range from 60 to over 120 inches, and compressive launch and ascent loads can exceed -100,000 lbs, or approximately two times the corresponding tensile loads. Allowing all possible compressive structural responses, including elastic buckling, were primary considerations for designing the test hardware. NASA's industry partner designed and built highly loaded struts that were delivered to NASA for testing. Their design, fabricated on a washout mandrel, had a uniform-diameter composite tube with composite tapered ends. Each tapered end contained a titanium end fitting with facing conical ramps that are overlaid and overwrapped with composite materials. The highly loaded struts were loaded in both tension and compression, with ultimate failure produced in compression. Test results for these struts are presented and discussed, along with measured deflections, strains and observed failure mechanisms.
Highly Loaded Composite Strut Test Development and Results
Advanced Composites Centre for Innovation and Science (ACCIS) Doctoral Training Centre ; 2012 ; Bristol, GB
2012-01-11
Sonstige
Keine Angabe
Englisch
Highly Loaded Composite Strut Test Results
NTRS | 2011
|Highly Loaded Composite Strut Test Results
NTIS | 2011
|Highly Loaded Composite Strut Test Development
NTRS | 2011
|Highly Loaded Composite Strut Test Development
AIAA | 2011
|Highly Loaded Composite Strut Test Development
British Library Conference Proceedings | 2011
|