This work presents the results of FUN3D and USM3D analyses that were performed for the 4th AIAA Propulsion Aerodynamics Workshop. The workshop was separated into three sections that focus on internal duct flows, nozzle flows, and a special topic of interest. This paper focuses on the nozzle section while an accompanying paper discusses the analyses performed for the internal duct flow section. For the nozzle flow section, the participants were provided with two configurations consisting of a rectangular convergent nozzle with and without an aft-deck. User-generated grids were developed under the guidelines of the workshop for the present analyses. The results show that both solvers compare favorably to the experimental results for the baseline nozzle with the largest differences observed at the lower NPR values. Additionally, both solvers showed favorable agreement with the experimental data for the pressures on the surface of the aft-deck. However, neither solver was able to match the jet flow further downstream for the nozzle with aft-deck configuration. A turbulence model study was conducted to compare the two-equation SST model, SA-QCR model, and two-equation k-kL model (FUN3D only). The results show that the SA-QCR turbulence model was unable to match the experimental results downstream of the nozzle. The k-kL model was shown to better match the experimental data compared to the SST model for most cases simulated using the FUN3D flow solver. Suggestions for future workshops include gridding guidelines similar ion Workshop series for the grid refinement study and a reduction in scope to allow for more detailed exploration of the individual problems. rticipation by reducing time requirements
FUN3D and USM3D Analysis of the 4th AIAA Propulsion Aerodynamics Workshop Nozzle Test Case
2019 AIAA Propulsion and Energy Forum ; 2019 ; Indianapolis, IN, United States
2019-08-19
Aufsatz (Konferenz)
Keine Angabe
Englisch