An electrically conductive elastomer was evaluated as a material candidate for a spacecraft seal. The elastomer used electrically conductive constituents as a means to reduce the resistance between mating interfaces of a sealed joint to meet spacecraft electrical bonding requirements. The compound's outgassing levels were compared against published NASA requirements. The compound was formed into a hollow O-ring seal and its compression set was measured. The O-ring seal was placed into an interface and the electrical resistance and leak rate were quantified. The amount of force required to fully compress the test article in the sealing interface and the force needed to separate the joint were also measured. The outgassing and resistance measurements were below the maximum allowable levels. The room temperature compression set and leak rates were fairly high when compared against other typical spacecraft seal materials, but were not excessive. The compression and adhesion forces were desirably low. Overall, the performance of the elastomer compound was sufficient to be considered for future spacecraft seal applications.
Evaluation of a Conductive Elastomer Seal for Spacecraft
AIAA Joint Propulsion Conference ; 2016 ; Salt Lake City, UT, United States
2016-07-25
Aufsatz (Konferenz)
Keine Angabe
Englisch
An Electrically Conductive Elastomer Seal for Spacecraft
AIAA | 2016
|AN ELECTRICALLY CONDUCTIVE ELASTOMER SEAL FOR SPACECRAFT (AIAA 2016-4923)
British Library Conference Proceedings | 2016
|Analysis of Elastomer Seal Life Cycle Integrity
British Library Conference Proceedings | 2000
|Coolant seal elastomer for diesel engine head gasket
Kraftfahrwesen | 1993
|SCATHA conductive spacecraft materials development
AIAA | 1983
|