Low-pressure turbine (LPT) airfoils are subject to increasingly stronger pressure gradients as designers impose higher loading in an effort to improve efficiency and lower cost by reducing the number of airfoils in an engine. When the adverse pressure gradient on the suction side of these airfoils becomes strong enough, the boundary layer will separate. Separation bubbles, particularly those that fail to reattach, can result in a significant loss of lift and a subsequent degradation of engine efficiency. The problem is particularly relevant in aircraft engines. Airfoils optimized to produce maximum power under takeoff conditions may still experience boundary layer separation at cruise conditions because of the thinner air and lower Reynolds numbers at altitude. Component efficiency can drop significantly between takeoff and cruise conditions. The decrease is about 2 percent in large commercial transport engines, and it could be as large as 7 percent in smaller engines operating at higher altitudes. Therefore, it is very beneficial to eliminate, or at least reduce, the separation bubble.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Synthetic Vortex Generator Jets Used to Control Separation on Low-Pressure Turbine Airfoils


    Beteiligte:


    Erscheinungsdatum :

    01.06.2005


    Medientyp :

    Sonstige


    Format :

    Keine Angabe


    Sprache :

    Englisch






    Flow Control on Low-Pressure Turbine Airfoils Using Vortex Generator Jets

    Volino, Ralph J. / Ibrahim, Mounir B. / Kartuzova, Olga | NTRS | 2010


    Control of Low-Pressure Turbine Separation Using Vortex-Generator Jets

    Rolf Sondergaard / Richard B. Rivir / Jeffrey P. Bons | AIAA | 2002


    Control of low-pressure turbine separation using vortex generator jets

    Bons, Jeffrey / Sondergaard, Rolf / Rivir, Richard | AIAA | 1999